User guide

4
Operation
Operation l 4-155
Cutter Control Instructions: Home
Offset
Exit or Prev, If no change is required press Exit or Prev to return to the
Maintenance Area screen.
Raise will increase the value by 1.0. The key can be pressed once for each 1.0
increment required or held down to scroll up. Releasing the key will freeze the
value at the last value.
Lower will decrease the value by 1.0. The key can be pressed once for each 1.0
decrement required or held down to scroll down. Releasing the key will freeze the
value at the last value.
Numeric keys
Key in the distance desired and press enter. The decimal place is fixed so remem-
ber this when entering the value. If you require 15.0 degrees you must key in 150
and then press enter. Keying only 15 will set the distance to 01.5 degrees.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return
to the Maintenance Area screen. If it is wrong press the delete key and the previous
value will reappear.
(continued)