User guide

4
Operation
Operation l 4-151
Cutter Control Instructions: Unit of
Measure
(continued)
Scale Softkey
By pressing the soft key located under the word Scale on the Encoder Area Screen,
there are two sub-menus, Dist., and Counts accessible.
Additional information on
how to access this screen can be found in the Maintenance Area of the operator
display overview in Appendix G of this manual.
Exit or Prev, Pressing Exit or Prev will return the display to the Encoder Area
screen.
SETTING THE SCALE FACTOR
The Encoder mode uses a scale factor to compensate for configurations that differ
from the standard (a measuring wheel with a 1 foot circumference; a 3000 bi-
directional quadrature pulse encoder; and English units of measure). The prescale
value is set at the factory for your equipment and typical unit of measurement.
However, it may occasionally be necessary to adjust the prescale value.