User guide

4-150 l Operation
Cutter Control Instructions:
Encoder Direction
(continued)
If a negative symbol is shown to the left of the count value on the main mode
screen the encoder signal is reversed, i.e. rotating in the wrong direction. The
Cutter will not function while the encoder is going negative. The direction function
corrects this by changing what the servo drive interprets as a positive direction,
CW or CCW rotation.
Cutter Control Instructions: Unit of
Measure
UNIT OF MEASURE SOFTKEY
By pressing the soft key located under the word U/M on the Encoder Area screen,
the Eng. Units can be set.
Exit or Prev, Pressing Exit or Prev will return the display to the Encoder Area
screen.
in./mm. Softkeys
Pressing the soft key located under in. or mm. Changes all displayed measure-
ments to the respective unit of measure.
The scaled distance must now be set for the desired unit. See the Scale Area Dist.
Softkey description.
(continued)