User guide

Cutter Control Instructions: Encoder
Area
(continued)
Encdr Softkey
By pressing the soft key located under the word Encdr on the Maint. Area Screen,
there are three sub-menus, Drctn, U/M, and Scale accessible. Additional information
on how to access this screen can be found in the Maintenance Area of the operator dis-
play overview section of this manual.
Exit or Prev, Pressing Exit or Prev will return the display to the Maint. Area screen.
Cutter Control Instructions: Encoder
Direction
DIRECTION SOFTKEY
By pressing the soft key located under the word Dirctn on the Encdr. Area Screen, the
direction of the encoder rotation can be changed. Located on the lower left side of the
display is the status text (INCORRECT/CORRECT) for the encoder direction.
Exit or Prev, Pressing Exit or Prev will return the display to the Encoder Area screen.
Change Softkey
With the machine stopped, by pressing the soft key located under the word Change.
The direction of the encoder is reversed. After the change if the count direction is posi-
tive, the status text will now display the word CORRECT.
Attempting to change the encoder direction with the cutter running will result in the
following message.
This message will be displayed for 3 seconds or until any key is pressed. Press stop on
the operator panel then try again.
Operation l 4-149
4
Operation
(continued)