User guide

4-148 l Operation
Cutter Control Instructions:
Encoder Area
Menus are a convenient way to access and monitor parameters that do not need to
be altered often, i.e. home position, encoder direction, scale or unit of measure. In
addition, preventive maintenance parameters can be monitored for trouble- shoot-
ing and scheduling purposes.
Factory Softkey
This area is password protected for factory use only.
Please do not attempt to get around the password protection as parameters beyond
this point are used for calibration and setup. These parameters should only be mod-
ified by trained personal. Improper settings will reduce the performance and possi-
bly cause severe damage to your machine.
Maint. Softkey
Located under the word Maint. is the Maintenance soft key. The Maintenance area
is password protected. This area should only be accessed by qualified personal.
After pressing the Maintenance Softkey, the password entry screen is displayed.
With the numeral keys press 6 2 0 9 then the Enter key to access the maintenance
area. An improper password will cause the message below to be displayed for 3
seconds.
There are three sub-menus, Encdr, Home, and P/M accessible in the maintenance
area.
Exit or Prev, Pressing Exit or Prev will return the display to the Menu Area
screen.
(continued)