User guide

4-142 l Operation
Cutter Control Instructions:
Blade Count Screen
BLADE COUNT SCREEN
By pressing the soft key located under the word Blade or Count depending on the
current mode, the preset for the blade count is available.
Additional information on
how to access this screen can be found in the operator display overview in
Appendix G of this manual.
The number shown is the current blade count preset, i.e. the number of blades
mounted to the cutter head. A cursor will appear in the least significant digit. The
user has a choice of ways to adjust this number.
Exit or Prev, if no change is required press Exit or Prev to return to the Blade
Select or Main Mode Screen.
Raise will increase the preset by 1. The key can be pressed once for each 1
increment required or held down to scroll up. Releasing the key will freeze the
preset at the last value then press enter.
Lower will decrease the preset by 1. The key can be pressed once for each 1
decrement required or held down to scroll down. Releasing the key will freeze
the preset at the last value then press enter.
Numeric keys
Key in the number of blades mounted and press enter. If the value entered is out
of range an error message with the valid range will be displayed.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and
return to the Blade Select or Main Mode Screen. If it is wrong press the delete
key and the previous preset will reappear.