User guide

Cutter Control Instructions:
Blade Speed Screen
BLADE SPEED SCREEN
By pressing the soft key located under the word Blade or Speed depending on the
current mode, the preset for that modes blade speed is available.
Additional infor-
mation on how to access this screen can be found in the operator display overview
in Appendix G of this manual.
The number shown is the active modes current blade speed preset, i.e. the speed
the blade will pass through the part. A cursor will appear in the least significant
digit. The user has a choice of ways to adjust this number.
Exit or Prev, if no change is required press Exit or Prev to return to the Blade
Select or Main Mode Screen.
Raise will increase the preset by 1.0. The key can be pressed once for each 1.0
increment required or held down to scroll up. Releasing the key will freeze the
preset at the last value then press enter.
Lower will decrease the preset by 1.0. The key can be pressed once for each
1.0 decrement required or held down to scroll down. Releasing the key will
freeze the preset at the last value then press enter.
Numeric keys
Key in the time required and press enter. The decimal place is fixed so remem-
ber this when entering the preset. If you require 750.0 rpm you must key in
7500 and then press enter. Keying only 750 will set the speed to 075.0 rpm and
an error message with the valid range will be displayed.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and
return to the Blade Select or Main Mode Screen. If it is wrong press the delete
key and the previous preset will reappear.
4
Operation
Operation l 4-141