User guide

Cutter Control Instructions:
Hold-Off Screen
HOLD-OFF TIME SCREEN
By pressing the soft key located under the word Time on the Main End Sense
Mode Screen, the preset for the hold-off timer is available.
Additional information
on how to access this screen can be found in the operator display overview in
Appendix G of this manual
.
The number shown is the current hold-off time preset, i.e. the time interval to
ignore the photo eye and avoid false cuts. A cursor will appear in the least signifi-
cant digit. The user has a choice of ways to adjust this number.
Exit or Prev, If no change is required press Exit or Prev to return to the Main End
Sense Mode Screen.
Raise will increase the preset by 0.010 second. The key can be pressed once for
each 0.010 second increment required or held down to scroll up. Releasing the key
will freeze the preset at the last value then press enter.
Lower will decrease the preset by 0.010 second. The key can be pressed once for
each 0.010 seconds decrement required or held down to scroll down. Releasing the
key will freeze the preset at the last value then press enter.
Numeric keys
Key in the time required and press enter. The decimal place is fixed so remember
this when entering the preset. If you require 1.000 seconds you must key in 1000
and then press enter. Keying only 1 will set the time to 0.001 seconds and an error
message will be displayed.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return
to the Main End Sense Mode screen. If it is wrong press the delete key and the
previous preset will reappear.
4-140 l Operation