User guide

Cutter Control Instructions: Time
Screen
TIME SCREEN
By pressing the soft key located under the word Time on the Main Timer Mode
Screen, the preset for the timer is available.
Additional information on how to
access this screen can be found in the operator display overview in Appendix G of
this manual
.
The number shown is the current time preset value, i.e. the time interval to cut the
product. A cursor will appear in the least significant digit. The user has a choice of
ways to adjust this number.
Exit or Prev, If no change is required press Exit or Prev to return to the Main
Timer Mode Screen.
Raise will increase the preset by 0.010 second. The key can be pressed once for
each 0.010 second increment required or held down to scroll up. Releasing the key
will freeze the preset at the last value then press enter.
Lower will decrease the preset by 0.010 second. The key can be pressed once for
each 0.010 second decrement required or held down to scroll down. Releasing the
key will freeze the preset at the last value then press enter.
Numeric keys
Key in the time required and press enter. The decimal place is fixed so remember
this when entering the preset. If you require 1.5 seconds you must key in 1500 and
then press enter. Keying only 15 will set the time to 0.015 seconds.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return
to the Main Timer Mode screen. If it is wrong press the delete key and the previ-
ous preset will reappear.
4
Operation
Operation l 4-139