User guide

Cutter Control Instructions: Preset
to Run Screen
PRESETS TO RUN SCREEN
By pressing the soft key located under the word #Prst on any Length Screen, the
value for the number of presets to run is available.
Additional information on how
to access this screen can be found on the multiple preset example in the operator
display overview in Appendix G of this manual
.
The number shown is the current number of presets to run value, i.e. how many
measurement presets and batches to run. The acceptable range for this value is 1 to
4. The cutter will process preset#1/batch#1 then #2 then #3 then #4 and back to #1
continuously. If a 2 is entered only preset/batch 1 and 2 are processed. A cursor
will appear in the least significant digit. The user has a choice of ways to adjust
this number.
Exit or Prev, If no change is required press Exit or Prev to return to the previous
Length Screen.
Raise will increase the number by 1. The key can be pressed once for each incre-
ment of 1 required or held down to scroll up. Releasing the key will freeze the pre-
set at the last value then press enter.
Lower will decrease the preset by 1. The key can be pressed once for each decre-
ment of 1 required or held down to scroll down. Releasing the key will freeze the
preset at the last value then press enter.
Numeric keys
Key in the number required and press enter. If you require 4 presets key in 4 and
then press enter.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return
to the Main Timer Mode screen. If it is wrong press the delete key and the previ-
ous preset will reappear.
4-138 l Operation