User guide

Cutter Control Instructions: Length
Screen
LENGTH SCREEN
By pressing the soft key located under the word Length on the Encoder, Follower
or Auto Mode Main Screen, the preset for the Length counter is available.
Additional information on how to access this screen can be found in the operator
display overview in Appendix G of this manual.
The number shown is the current length preset value, i.e. the length to cut the prod-
uct. A cursor will appear in the least significant digit. The user has a choice of
ways to adjust this number. Pressing the #Prst/Softkey3 accesses the number of
presets to run screen. This feature is only available with the multiple preset/batch
option.
Exit or Prev, if no change is required press Exit or
Prev to return to the Main screen.
Raise will increase the preset by 0.010 inch. The key can be pressed once for each
0.010 inches increment required or held down to scroll up. Releasing the key will
freeze the preset at the last value then press enter.
Lower will decrease the preset by 0.010 inch. The key can be pressed once for
each 0.010 inch decrement required or held down to scroll down. Releasing the
key will freeze the preset at the last value then press enter.
Numeric keys
Key in the length required and press enter. The decimal place is fixed so remember
this when entering the preset. If you require 24 inches you must key in 24000 and
then press enter. Keying only 24 will set the length to 0.024 inches.
Enter or Delete?
If the keyed in number is correct press the enter key for it to be accepted and return
to the Main screen. If it is wrong press the delete key and the previous preset will
reappear.
4
Operation
Operation l 4-137