User guide

4
Operation
Operation l 4-135
Cutter Control Instructions: Batch
Screen
(continued)
Batch Select Area Screen
Under the batch counter, on the left is a soft key labeled Change. Pressing this key
displays the Select Batch Area screen.
Additional information on how to access
this screen can be found in the operator display overview in Appendix G of this
manual.
This screen provides access to the batch Preset/softkey1 or batch Alarm/softkey3
areas. Pressing Exit/softkey2 returns the display to the batch counter screen. If no
selection is made within 30 seconds the display returns to batch counter screen.
Batch Preset Screen
By pressing the soft key located under the word Batch on the Batch Area Screen,
the preset for the Batch counter is available.
The number shown is the current batch preset. A cursor will appear in the least sig-
nificant digit. The user has a choice of ways to adjust this number.
Exit or Prev, If no change is required press Exit or Prev to return to the Main
screen.
Raise will increase the preset by 1. The key can be pressed once for each incre-
ment required or held down to scroll up. Releasing the key will freeze the preset at
the last value.
Lower will decrease the preset by 1. The key can be pressed once for each decre-
ment required or held down to scroll down. Releasing the key will freeze the preset
at the last value.
(continued)