User guide

4-132 l Operation
Cutter Control Instructions
Menu function key is used to access the Menu Area
This area can only be accessed from the main display screen for each mode. See the
Menu Area section for more information.
Parts Select Area Screen
Under the current mode on the left side of the bottom line of the display is a soft key
labeled Parts. Pressing this key accesses the Parts Select Screen.
This screen provides access to the parts Total/softkey1 or Batch/softkey3 areas.
Pressing Exit/softkey2 returns the display to the active main screen. If no selection is
made within 30 seconds the display returns to the active main screen.
EXIT or PREV, fixed function keys return the display to the previous screen.
Cutter Control Instructions: Total
Screen
TOTAL SCREEN
By pressing softkey1 located under the word Total on the Parts Select Screen, a
seven-decade total counter is available.
Additional information on how to access this
screen can be found in the operator display overview in Appendix G of this manual.
This is typically used to count cut pieces during the day or days that the product is
being produced. Sample or manual cuts are not counted. When enabled the count
continues to accumulate even if the total display is not being viewed. It is also possi-
ble to turn this counter off or on.
On/Off Softkey1
Under the counter on the left is a soft key labeled On or Off. Pressing this key while
On is displayed will disable the counter. Likewise pressing this key while Off is dis-
played enables the counter.
(continued)