User guide

Profile/Bubble/Taper Mode -
Digital Outputs Page Description
(continued)
Setting Output Length and Duration
On At
Each Digital Output has an “On At” point. This is the distance from the beginning of
the sequence to when the output turns on. In the sample Output 1 will turn on 1.0"
from the start of the sequence. In this example, the length is the distance air pressure
will turn on and the duration is length the air will remain on. Each output “On At”
length is relative to the beginning of the sequence.
To adjust the length for each setpoint:
1
Press the On At Length window. A pop-up keyboard appears.
2
Enter the new length that the air pressure will turn on. This distance is from
the beginning of the sequence length.
3
Press “Enter”. The pop-up keyboard is removed.
4
Repeat this step for the remainder of digital outputs to be used. If more than
four outputs are used, additional buttons will appear to display what outputs are
available. The buttons will contain text showing additional outputs in groups of
four, “1-4”, “5-8”, “9-12” and “13-16”. Pressing any of these buttons will display
the corresponding outputs.
Operation l 4-125
4
Operation
(continued)