User guide

Profile/Bubble/Taper Mode -
Analog Outputs Page Description
This page is for setting up analog profiles that occur in synchronization with the
Velocity Profile. The velocity waveform appears in the graph area as a blue trace to
aid the placement and sizing of the analog waveforms.
To access the Profile/Bubble/Taper Analog Output Sub-Page:
1
Press the Set Up 1 tab and then press the Modes sub tab.
2
Select Profile/Bubble/Taper Mode for both the cutter and puller sections.
“Profile” will be displayed at the bottom of each section when properly
selected.
3
Press the Main tab.
4
A “Profile Settings” button will now be displayed in the cutter portion’s
length window.
5
Press the “Profile Settings” button to access the Profile/Bubble/Taper
Main Page.
6
Press the Analog Outputs tab to access the Profile/Bubble/Taper Analog
Outputs Sub-Page.
Operation l 4-119
4
Operation
(continued)