User guide

Profile/Bubble/Taper Mode -

Velocity Page Description

(continued)

Ramp Type

Ramp types can be changed while the machine is running to test ramp effect on types

of extruded material. Four types of ramps are available, a S-Curve type may be used

to provide rounding of the extruded at the ramp ends. This may help to reduce the

amount of points needed to create a product.

See Operation Section entitled, Set Up 1

Page Description, Ramps Page for a description of each of the 4 types of ramps.

To alter the ramp type on extruded material:

1 Press the “Ramp Type” button.

2 Select the type of ramp from the pop-up Ramp Type window by pressing on

the radio button located to the left of the ramp to be used.

3 Press the “Exit” button once the ramp type has been selected.

4-112 l Operation

NOTE: Rounding of edges

occurs naturally in the product

due to elasticity.