User guide

Profile/Bubble/Taper Mode -

Velocity Page Description

Index (continued)

• Sequence (Total Length) - This is a copy of the same preset that is on the Profile

Page.

• Tip Velocity - This sets the tip speed for the profile when On Line and the Body

On/Off is set to “On”. It also sets the maximum speed for the speed points in the

table below the Tip Velocity preset.

• Ramp Length - This is the length used for the speed transition (velocity change)

for a set index.

• Level Length - This is the length that will be maintained at the set velocity for

this index.

• Velocity - This is the target velocity for the index to be achieved at the end of the

front edge ramp. Target velocities may be higher or lower than the previous veloc-

ity as long as they do not exceed the Tip Velocity. The front edge ramp can be used

for increasing (ramp up) or decreasing (ramp down).

• Bubble Total - A running total of the bubble length is shown here.

• Clear - This button resets all lengths to zero except Sequence Length. In addition,

all velocities are set to the Tip Velocity.

Operation l 4-111

Operation

NOTE: All values can be

changed by pressing individual

windows and using the key-

board method to alter the value.

See Operation Section entitled

Setting the Cutter Length Scroll

and Keyboard Methods.