User guide

Profile/Bubble/Taper Mode -
Profile Page Description
Puller
Velocity (FPM) (continued)
If the “Body On/Off” button is set to “On”, the velocity section (FPM) becomes
locked out. The value shown for speed is the actual speed only, which can not be
altered. The scroll buttons will disappear and a (Read only) message appears.
Sequence (Total Length)
This defines the entire length of the Profile/Bubble/Taper product including any
portions that are to be scrapped. This length can only be altered by using the key-
board method.
To change the Sequence (Total Length):
1 Press the Sequence (Total Length) window. A pop-up keyboard appears
2 Key in the new Sequence (Total) Length and press “Enter”. The pop-up
keyboard is removed.
The “Cut Enable On/Off” button within the Sequence (Total Length) window is
used with Profile/Bubble/Taper products when the “Body On/Off” button is turned
“On”. When enabled a cut is made at the beginning of the sequence (total length).
This cut would normally occur in the center of the tip section (the smallest diame-
ter section of the Profile/Bubble/Taper tubing product).
4-102 l Operation
(continued)