User guide

Encoder Sequence Page

Description

Encoder Sequence mode is a variation of Encoder mode that has up to four

lengths.

See Operation Section entitled, Modes Page Description.

A “Sequence Settings” button replaces the Length preset that appears on the Main

Page when this mode is selected.

See Operation Section entitled, Configuring the

Set Up 1 Folder, Selecting Modes.

The four lengths and a Sequence Amount window are shown the main Encoder

Sequence Page. In this example, Sequence Amount is set to 2 which means

Lengths 1 and 2 will be produced alternatively. Lengths 3 and 4 in this example

will not be produced.

To access the Encoder Sequence Main Sub-Page:

1 Press the Set Up 1 tab and then press the Modes sub-tab.

2 Select Encoder Sequence Mode for the cutter section. “Sequence” will be

displayed at the bottom of the cutter section when selected properly.

3 Press the Main Page tab.

4 A “Sequence Settings” button will now be displayed in the cutter portion’s

length window.

5 Press the “Sequence Settings” button to access the Encoder Sequence

Mode Main Sub-Page.

Operation l 4-93

Operation