User guide

Quality Page Description (continued)

Counters

Good and Bad counters are provided. The Good counter will only count product

that has been labeled good at the cutter and the Bad counter will only count prod-

uct that has been labeled bad at the cutter. Press the “Reset” button to reset both

counts together. The counters will only be used when the Quality Control is

enabled.

Take Away/Blow Off

Check the Available check box when using a Take Away/Blow Off Conveyor.

When the box is checked the Total and Batch counters increase when good pieces

are blown off the conveyor not when they are cut at the Combination

Puller/Cutter.

See Operation Section, Main Page Description, Configuring Blow

Off Settings.

Deferred Sample

This feature is only for the Time and Encoder Modes. It is used to obtain a set

sample length for quality assurance. Pressing the “Sample” button will provide

one additional cut within the product for the sample. This sample length will be

inserted in between the normal cut sequence. For example, if cut lengths are set to

12 inches and sample is set to 2 inches there will be one 2 inch length produced

after pressing the “Sample” button. This will be inserted after the next 12 inch cut

is made. The sample length is a user preference.

4-90 l Operation

NOTE: The Deferred

Sample Length can be

changed by pressing its

individual windows and

using the keyboard method

to alter the value.

See

Operation Section entitled

Setting the Cutter Length

Scroll and Keyboard

Methods.