User guide

Operation l 4-89

Quality Page Description (continued)

When Bad

The Scrap Length setting can be set and used to remove product that has been

produced and determined that it was bad by Quality Control.

See Operation

Section entitled, Quality Page Description, Offsets.

This setting is available for

Time and Encoder Modes. The scrap length should be set twice as long as good

lengths to help differentiate them from one another.

To adjust the Scrap Length:

1 Press the Scrap Length window. A numeric pop-up keyboard appears.

2 Key in the new length amount. Ensure that the Scrap Length is set at least

twice as long as lengths that are good.

3 Press “Enter”. The pop-up keyboard is removed.

• Use this Length - The “Use this Length” check box should be checked when

the entered scrap length is required. If left unchecked, the scrap length will be

the length set on the Main Page Cut Length window.

• Don’t Cut - Check the “Don’t Cut” check box if the cutter should stop cutting

for bad product.

Operation