User guide

Quality Page Description

Offsets (continued)

When using offsets with the cutter the “Distance to Good” length should be set

higher than the “Distance to Bad” length. If the values are not set correctly a

warning message will be displayed.

To adjust the “Distance to Good” and Distance to Bad” length:

1 Press the Distance to Good or Distance to Bad window. A numeric pop-up

keyboard appears.

2 Key in the new length amount. Ensure that the “Distance to Good” length is

set higher than the “Distance to Bad” length.

3 Press “Enter”. The pop-up keyboard is removed.

• QC Enable - Should be checked when Quality Control is in use. Leave the QC

Enable uncheck if Quality Control is not used.

• Ignore Offsets - Should be checked if offsets are set in the remote gauge. This

option causes the offset presets on this page to be ignored.

Operation l 4-87

Operation