User guide

Operation l 4-79
4
Operation
Angles Page Description (continued)
Cut Angle
Cut Angle is the position where the blade is in the cutter bushing. The center of
the bushing or blade just entering the bushing can be used.
This position is used for captures used in the Follower mode and for Repeatability
testing.
To change the Cut Angle:
1 Press the Cut Angle Degree window. A numeric pop-up keyboard appears.
2 Key in the new Cut Angle. Ensure that the distance from the Park Angle to
the Cut Angle allows the cutter blade to reach its required speed before it enters
the material to be cut.
See Operation Section entitled, Ramps Page Description,
Calculations.
3 Then press “Enter”. The pop-up keyboard is removed.
4 The Cut Angle will appear in the Cut Angle window.
To check the Cut Angle:
1 Press the Cut Angle “Go Bush” button. This will rotate the cutter blade to
the degree entered at the Cut Angle Degree window. The cutter must be
stopped but enabled for these buttons to function. The puller provides a “Cutter
Drive Enable” when it is running.