User guide

Angles Page Description (continued)
Park Angle
Park Angle is the place to park the blade. It is typical to park the blade 60 to 180
degrees before the cut angle. Acceleration can be checked on the Ramps Page
using the Calculations at the bottom of the page to ensure blade can reach speed
in the angle provided.
See Operation Section entitled, Ramps Page Description,
Calculations.
To change the Park Angle:
1 Press the Park Angle Degree window. A numeric pop-up keyboard appears.
2 Key in the new Park Angle. Ensure that the distance from the Park Angle to
the Cut Angle allows the cutter blade to reach its required speed before it enters
the material to be cut.
3 Then press “Enter”. The pop-up keyboard is removed.
4 The Park Angle will appear in the Park Angle window and will then be
active.
To check the Park Angle:
1 Press the Park Angle “Go Park” button. This will rotate the cutter blade to
the degree entered at the Park Angle Degree window. The cutter must be
stopped but enabled for these buttons to function. The puller provides a “Cutter
Drive Enable” when it is running.
4-78 l Operation