User guide

Angles Page Description
To access the Angles Page:
1
Press the Set Up 1 tab.
2 Press the Angles sub-tab.
Positional servomotors will require a reference point. This position is known as
Home or Zero. On a cutter the Home reference must occur at one point within the
360-degree turn of the blade arm.
• Reducer - If the motor has a gear reducer, a proximity sensor is used to detect
a target (usually a bolt) that is mounted on the blade arm.
• No Reducer - The internal zero marker that is built into the motor is used.
To position the servomotor to Zero or “Home”:
1
Press the “Go Zero” button to place the cutter arm in the Zero or “Home”
position.
Operation l 4-77
4
Operation