User guide

Scale Page Description
Maximum Speed and Volts (continued)
An analog output is available that can be used to remotely monitor the puller
speed. In the example 250 FPM will generate 10 volts DC.
To set the voltage output:
1 Press the Puller section’s Maximum Speed and Velocity, Volts Out
window. A numeric pop-up keyboard appears.
2 Key in the new Volts Out amount. This amount is dependent on the type of
puller that is used and its set speed (FPM), which will determine the amount of
volts that are produced.
3 Then press “Enter”. The pop-up keyboard is removed.
4-72 l Operation