User guide

Operation l 4-65
4
Operation
Scale Page Description (continued)
Cutter - Encoder Input
Cutter Encoder Input comes from the encoder that is on the puller and is used to
scale the encoder input used by the cutter. Two presets are used to set the counts
per distance of the encoder input.
To change the Encoder Input distance:
1 Press the Cutter section’s Encoder Input distance window. A numeric pop-
up keyboard appears.
2 Key in the new distance. This is the length scaling of the material passing
through the cutter bushing.
3 Then press “Enter”. The pop-up keyboard is removed.
The counts per distance scale is used to scale the cutter’s encoder input so that
lengths entered at the cutter are the lengths that are made.
To change the Encoder Input Counts:
1 Press the Cutter section’s Encoder Input Count window. A numeric pop-
up keyboard appears.
2 Key in the Count amount.
3 Then press “Enter”. The pop-up keyboard is removed.