User guide

Operation l 4-63

Operation

Ramps Page Description

Puller (continued)

To change the Puller Ramp type:

Press either the Linear, 1/4 S-Curve, 5/8 S-Curve or S-Curve radio button.

A dot will appear in the radio button of the selected curve type.

• Acceleration and Deceleration preset is the average rate of change that will

be used for speed changes. For example, a puller set to 100 FPM will acceler-

ate from zero in one second with a 100.0 FPM/S ramp.

• Stop Deceleration setting of the puller is dependent upon they type of puller

used. Stop deceleration is used to provide a quicker stop as a result of the

“Puller Stop” button being pressed. The stop rate should be set larger

than the normal ramp.

Calculations

Included at the lower portion of the page are sets of calculations. These have no

effect on operation. They serve to provide information only.

NOTE: All values can be

changed by pressing individual

windows and using the key-

board method to alter the value.

See Setting the Cutter Length,

Keyboard Method.