User guide

Ramps Page Description
To access the Ramps Page:
1
Press the Set Up 1 tab.
2 Press the Ramps sub-tab.
Cutter
Four choices of ramp styles are available. S-Curves provide less wear on the
mechanics of the cutter by use of smoothing at the beginning and end of the ramp.
The middle of the profile is linear but uses a steeper gradient to compensate for
the smooth ends. No matter which option of ramp is chosen the time and distance
for a speed change will remain the same.
NOTE: Similar options are provided for each portion of the machine. Ramps are acceleration and
deceleration.
0
Encoders Page Description
The Encoders Page is for factory personnel only. Information contained in this
page will not be mentioned in this Operator Instruction Manual.
4-60 l Operation
(continued)