User guide

Scroll Page Descriptions
Puller Scrolls - Remote Contacts (continued)
The second Remote Contacts scroll preset is used for Ratio Modes such as Analog
or Follower Modes. A contact closure or switch will raise or lower the ratio by the
increment entered. An example of this is if the speed ratio increment is set to
0.010 one signal or press of the Remote Contact or switch would adjust the puller
to run at ±1% of its set speed. A further example is, if the ratio is set to 0.100, one
signal or press of the Remote Contact or switch would adjust the puller to run at
±10% of its set speed.
To change the Ratio Modes scroll increment:
1 Press the Ratio Modes window. A numeric pop-up keyboard appears.
2 Key in the new scroll increment. Lower product line speeds will require a
smaller increment change, higher product line speeds will require a larger
increment change.
3 Then press “Enter”. The pop-up keyboard is removed.
4 The new scroll increment will appear in the Ratio Modes window and will
then be available.
Operation l 4-57
4
Operation
NOTE: Remote Contacts scroll increments are dependent on the type of product that is
produced and user preference.
0