User guide

4-56 l Operation
Scroll Page Descriptions (continued)
Puller Scrolls - Remote Contacts
Two settings are available for remote contacts (laser gauge or switches that are
located at the extruder) that are used to increase or decrease the puller speed. One
is used for Speed Modes such as Master Mode. A contact closure or switch will
add or subtract this increment to the speed setpoint on the Main Page.
To change the Speed Modes scroll increment:
1 Press the Speed Modes FPM window. A numeric pop-up keyboard appears.
2 Key in the new scroll increment. Lower product line speeds will require a
smaller increment change, higher product line speeds will require a larger
increment change.
3 Then press “Enter”. The pop-up keyboard is removed.
4 The new scroll increment will appear in the Speed Modes window and will
then be available.
NOTE: Remote Contacts scroll increments are dependent on the type of product that is
produced and user preference.
0