User guide

Scroll Page Descriptions (continued)

Puller Scrolls - Panel

The (+) and (-) buttons on the puller control shown on the Main Page can be used

to add or subtract any of these four values to the speed setpoint. These values are

typically set to a range that will give both coarse and fine control. An operator can

use coarse settings to gradually bring the line up to speed during a startup. Finer

selections would then be used when getting close to the desired line speed. The

operator can switch through this list of settings on the Main Page by pressing the

puller Scroll Size window.

The values in this list can be set in any order. It is recommended that they be

placed in a descending order for line set up where the operator can begin with

coarse settings and then end with fine.

To change the Culler Scroll Size increments:

1 Press the first Puller Scrolls window. A numeric pop-up keyboard appears.

2 Key in the new scroll increment.

3 Then press “Enter”. The pop-up keyboard is removed.

4 The new puller scroll increment will appear in the Puller Scroll window

and will then be available.

5 Repeat steps for the remaining puller scroll increments.

Scroll amounts are the user preferred values.

Operation l 4-55

Operation