User guide

6-8 SECTION HEAD
CSC Servo Knife Cutters UGE047/1003
Symptom
◆ Burrs at cut site.
Possible cause
The bushings are not pro-
viding enough support
during cutting.
The bushing gap is too
wide.
The blade speed is too low.
Solution
Change bushing design to
make them more supportive.
The bushing gap should be no
more than .001-.003 inches
larger than the blade. Check
and adjust if necessary.
Low blade speeds can cause
excessive blade interruption.
Increase blade speed or
decrease the blade cut path
area.
PRODUCT
QUALITY
PROBLEMS
C
ONTINUED