User guide

The Trantorque coupling device connects the servo motor to
the cutter head. It is important that it is tightened to the
proper torque.
Carefully remove the cutter blade.
Check to make sure both the shaft and com-
ponent bore
of the Trantorque coupling device are
completely free of paint, grease, oil, and dirt. If necessary,
clean the surfaces with a non-petroleum based solvent,
such as isopropyl alcohol.
Use a torque wrench to make sure the nut is tight-
ened to the proper installation torque (2000 in-lb or
225 N-m). Do not overtighten; it can cause damage to the
unit.
CHECKING
TORQUE
CSC Servo Knife Cutters UGE047/1003
5-12 MAINTENANCE
WARNING: No lubricants!
Use no lubricants on the Trantorque coupling
device.
1
2
DANGER: Sharp blades!
Always wear cut-resistant gloves when the cut-
ting chamber is open and when handling
blades. Never open cutting chamber without
locking out the cutter power and waiting until
the cutter head has stopped completely. Handle
blades with care at all times.
3