User guide

Follow all warnings and cautions listed at the beginning of the

Maintenance section of this User Guide.

Be sure the main power is disconnected and the

cutter is locked out.

Loosen the set screws that hold the cutter bushings.

Remove the cutter bushings.

Check the depth of the proximity switch

face for each bushing. It should be recessed no more than

0.010 inches, but should not interfere with the bushings

themselves.

Use an Allen wrench to check the tightness

of each proximity switch's retaining screw.

NOTE: You can damage the proximity switch if you

over-tighten the retaining screw.

Replace cutter bushings and check for proper cut-

ting blade alignment. (See Mounting the Cutter Bushings,

Section 3 and Appendix C).

Plug in the power cord and turn the main power dis-

connect to the on position if all other maintenance is com-

pleted.

ADJUSTING THE

PROXIMITY

SWITCHES

UGE047/1003 CSC Servo Knife Cutters

MAINTENANCE 5-9