User guide

● Weekly
❒❒
Cleaning the blade lubrication tray
(See Cleaning the Blade Tray, Section 5).
❒❒
Lubricating shafts on optional slide rail system
(See Lubricating the Slide Rail System, Section 5).
●
Monthly
❒❒
Checking hardware on the knife guard
Inspect the hardware on the knife guard (fasteners on
hinge and the clear blade guard window). Tighten as
needed.
❒❒
Checking bushing holder proximity switches
Inspect the sets screws which retain the bushing holder
proximity switches for tightness. Adjust as needed.
(See Adjusting the Proximity Switches, Section 5).
❒❒
Checking the metal draw latch
Inspect the latch on knife guard for wear and proper
tension. Readjust or replace as needed.
PREVENTATIVE
MAINTENANCE
SCHEDULE
C
ONTINUED
UGE047/1003 CSC Servo Knife Cutters
MAINTENANCE 5-5
❒❒
Clean the clear blade guard window
Clean using glass cleaner or plain water. Other materi-
als may cause premature loss of clarity or crazing.
●
Semi-annual (every 6 months)
❒❒
Inspecting electrical terminals
Check all electrical terminals for tightness; adjust as
needed. (See Checking Electrical Connections, Section
5).
❒❒
Checking torque on Trantorque coupling device
Check the tightness (torque) of the Trantorque coupling
device with a torque gauge. This device connects the
cutter head to the Micron reducer shaft. (See Checking
Torque, Section 5).
❒❒
Checking all electrical cables
Inspect all electrical cables for cuts and abrasions.
Replace as needed.
❒❒
Inspecting control panel lights
Check to make sure no LEDs or lights are burned out
on the control panel. Replace as needed.