User guide

MAKING
A
DJUSTMENTS
DURING
OPERATION
4-30 OPERATION
CSC Servo Knife Cutters UGE047/1003
There are several adjustments you can make during
normal cutting. These adjustments include:
● In Timer mode, adjust the time between cuts
● In Encoder and Follower modes, adjust the
length
● In Product mode, adjust the hold-off time
● In Flywheel mode, adjust blade speed (CSC only)
● Adjust blade speed in all modes except
Follower
● Perform a manual cut and reset the length by
pressing the manual cut button at any time during
on-demand cutting. Pressing Reset/Test has no
effect during continuous cutting.
● Count the total number of cuts by pressing the
Total On/Off soft key. Use the Reset button to
return the count to zero. This feature is useful for
collecting samples during a production run.
● Count the batches of cuts by pressing the Total
On/Off soft key. Use the Reset button to return the
count to zero. This feature is useful for collecting
samples during a production run.
● Stop cutting temporarily by setting Cut On/Off
to off. This allows you to view the cutting blade
(through the window) or perform other tasks with-
out shutting down the cutter.
NOTE: While the controller will allow you to
switch modes during operation, this is not
recommended.