User guide

UGE047/1003 CSC Servo Knife Cutters
Press the manual cut button and observe the
movement of the cutter blade. The cutter head makes a
single rotation and the blade moves through the cutter
bushings without interference.
Insert a piece of extrudate through the cut-
ter bushings.
Press the manual cut button.
A single cut is made
at the preset blade speed. (This works even if Cut On/Off
is off.)
Inspect the cut. If necessary, adjust the blade design
or blade speed. See, All About Cutter Blades, Appendix
B.
OPERATION 4-29
CHECKING CUT
QUALITY
4
3
2
1
If you have not already done so, check the cutter hardware,
power up the cutter, select cutting mode and blade speed, and
make a test cut to check cut quality.
When you are satisfied with cut quality, press the Cut On/Off
soft key and on is displayed, automatic operation begins.
When the extrudate is running within tolerance, cut it with a
knife or saw and feed it through the cutter bushings.
STARTING THE
SERVO CUTTER