User guide

4-20 OPERATION
CSC Servo Knife Cutters UGE047/1003
Menus are a convenient way to access and monitor parameters
that do not need to be altered often, i.e. home position,
encoder direction, scale or unit of measure. In addition, pre-
ventive maintenance parameters can be monitored for trouble
shooting and scheduling purposes.
Factory Softkey
This area is password protected for factory use only.
Please do not attempt to get around the password protection as
parameters beyond this point are used for calibration and
setup. These parameters should only be modified by trained
personal. Improper settings will reduce the performance and
possibly cause severe damage to your machine.
Maint. Softkey
Located under the word Maint. is the Maintenance soft key.
The Maintenance area is password protected. This area should
only be accessed by qualified personal. After
pressing the Maintenance Softkey, the password entry screen
is displayed. With the numeral keys press 6 2 0 9 then the
Enter key to access the maintenance area. An improper pass-
word will cause this message to be displayed for 3 seconds.
There are three sub-menus, Encdr, Home, and P/M accessible
in the maintenance area.
Exit or Prev, Pressing Exit or Prev will return the display to
the Menu Area screen.
CONTROL
INSTRUCTIONS
E
NCODER AREA
Continued