User guide

UGE047/1003 CSC Servo Knife Cutters
INSTALLATION 3-9
MOUNTING THE
CUTTER
BUSHINGS
Rotate the cutter head until the blade is positioned
in the gap between where the bushings go.
Slide the downstream bushing into position,
positioning it up to and barely touching the blade (use
feeler gauge). NOTE: the blade should not be deflected.
Tighten the set screw against the flat side of the
bushing to hold the bushing in position.
Slide the upstream bushing into position, posi-
tioning it up to but not touching the blade (using feeler
gauge).
Tighten the set screw against the flat side of the
bushing to hold the bushing in position.
Rotate the cutter head by hand to make sure the
bushings did not move, and the the blade still passes
through the gap between the bushings.
DANGER: Sharp blades!
Always wear cut-resistant gloves when the cut-
ting chamber is open and when handling
blades. Never open cutting chamber without
locking out the cutter power and waiting until
the cutter head stops spinning.
1
2
3
Upstream
Downstream
4
5
For more information about
setting and adjusting the gap
for the bushings, see About
Cutter Bushings in the
Appendix C.
6
Location of set screws