User guide

Measure the centerline height of the extrudate as it

exits the extrusion die. Adjust all equipment on the extru-

sion line (sizing tank, cooling tanks, belt puller, and cut-

ter) to this height.

Adjust the cutter's floorlock/caster assembly

to the center height of the extrusion line using a 16- or

18-inch adjustable wrench. Once the correct height is

reached, adjust the pad assembly to remove the weight

from the casters for operation. This minimizes machine

vibration during the cutting cycle.

Use a plumb line or laser to check for a

straight line

from the extrusion die through each line

component to the cutter bushings. Adjust as neces-

sary.

UGE047/1003 CSC Servo Knife Cutters

INSTALLATION 3-5