User guide

Conair CSC Series Servo Knife Cutters can cut extrudable
plastics and rubber both on- and off-line. Other extrudable
materials-foods, ceramics, magnets, soaps, etc.-may also be
cut depending on specific application requirements.
CSC cutters are available with different cutting capacities (2,
3, 4, and 5 inches) to suit your specific needs. The servo
motor size and cutter head material may also be optimized for
specific applications. While the standard cutter orientation is
right-to-left, cutters can also be made with a left-to-right ori-
entation (see Specifications, Section 2). (The illustrations in
this User Guide represent the standard right-to-left configura-
tion.)
CSC cutters are limited to a specific range of product sizes
based on each unit's cutting capacity. CSC cutters can operate
over a range of speeds (depending on which options were pur-
chased.) See Specifications, Section 2.
Different materials, line speeds, temperatures and material
cross-sections can result in different cutting torques. If you are
changing any of these parameters, consult your Conair service
personnel to be sure your equipment can handle the changes.
UGE047/1003 CSC Servo Knife Cutters
DESCRIPTION 2-3
TYPICAL
A
PPLICATIONS