User Manual

Fig. 3 Fig. 5Fig. 4
CLEANING AND DISINFECTING YOUR BATH SPA
1) Your Bath Spa can be cleaned with any mild detergent or soap. After removing plug,
cleaning is recommended after each use. Do not use strong chemical cleaners.
2) Disinfect your unit periodically to keep it bacteria free. With frequent use, disinfect weekly.
With infrequent use, disinfect after each use.
RECOMMENDED MASSAGING TIMES
Spa massage should generally last 15–20 minutes.
Caution: Read safety rules and operating instructions carefully. This product is intended for
indoor use on permanent, right-wall tubs. Do not use outdoors or on the walls of inflatable
tubs or pools.
HOW TO ATTACH YOUR BATH SPA TO YOUR TUB
1) Make sure the power knob is in the OFF position. The tub should be clean and empty of
water.
2) Extend the folding arm and position unit along edge of tub so the unit is inside the tub and
the arm is resting on edge (Fig. 3).
3) Moisten suction cups on motor housing of Bath Spa to increase grip.
4) Secure suction cups by gently applying even pressure on Bath Spa against tub wall
(Fig. 3).
5) Adjust suction cup on arm so that it adheres directly onto bathtub edge. See Fig. 4 and
Suction Cup Position Adjustment section following (Fig. 6).
6) Adjust height of motor assembly to desired depth by moving motor housing up or down
by hand. Built-in detentes will hold the position you desire (Fig. 5).
7) Water may spray if unit is not level when turned on.
SUCTION CUP POSITION ADJUSTMENT
Suction cup underneath the handle can be in one of two positions to suit different bathtubs.
(See Fig. 6)
Push and slide the suction cup to the desired position.
Position A: The outermost position for thick-sided tubs.
Position B: The innermost position for thin-sided tubs.
FITTING AND REMOVING FILTER CAPS
TO REMOVE CAPS
1) Turn cap about 20° counterclockwise (Fig. 7).
(Filter caps are located on either side of the motor
assembly.)
2) Line up single hash mark on cap with the center
seam on the back body of the unit.
3) Pull cap away from unit.
4) Rinse cap under water to remove hair, lint, etc.
TO REPLACE CAPS
1) Push cap into body so that single hash mark on cap lines up with the center seam on the
back body of the unit.
2) Turn cap clockwise about 20° until the double hash marks on the cap line up with the
center seam on the back body of the unit.
WARNING: To protect from excess lint, hair, etc., getting caught in motor, unit should
never be used with the filter mesh removed. Injury or damage to unit could result.
LIMITED ONE YEAR WARRANTY
(U.S. and Canada Only)
Conair will repair or replace (at our option) your appliance free of charge for 12 months from the
date of purchase if the appliance is defective in workmanship or materials.
To obtain service under this warranty, return the defective product to the service center listed
on back, together with your sales slip and $12.00 for postage and handling. California residents
need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions.
In the absence of a purchase receipt, the warranty period will be 12 months from the date of
manufacture. ANY IMPLIED WARRANTIES, OBLIGATIONS OR LIABILITIES, INCLUDING BUT
NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION
OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an
implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY,
EXPRESS OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of
special, incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which vary from
state to state.
Position B
Fig. 6
Dual Jet Bath Spa
Please register this product at: www.conair.com/registration
SERVICE CENTER
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
Visit us on the web at: www.conair.com
©2016 CONAIR CORPORATION
stock.image
BTS7
16PS020883
INSTRUCTION BOOKLET FOR ALL BTS7 MODELS
For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
Position A
Fig. 7
IB-10918C