Specifications

9.4 Replacing the backup battery on the control board of the

Condair GS

1. Set the Condair GS out of operation as described in chapter 7.5.

2. Undothescrew(phillipsscrewdriver)andremovetherightfrontpanel.

CAUTION!

The electroniccomponentsinsidethehumidierarevery sensitive to electrostatic discharge.

Beforecarryingoutthenextstep,appropriatemeasuresmustbetakentoprotecttheelectronic

componentsagainstdamagecausedbyelectrostaticdischarge(ESDprotection).

3. Undothe2screws“A”ofthedisplayandcontrolunit,thencarefullyremovethedisplayandcontrol

unit to the front.

4. Undothe7fasteningscrews“B”ofthecontrolboard,thencarefullypull-offthecontrolboardfrom

the display and control unit assembly.

5. Replacethebackupbattery(CR2032,Lithium3V).

6. Reassemble the unit in reverse order.

7. If necessary set date and time (see operating instructions of the control).

WARNING!

Environmentalhazard!

The old battery must be returned to an authorised collecting point for correct disposal/

recyclinginaccordancewithlocalregulations.Innocasetheoldbatterymustbe

disposedofinthedomesticwasteorintotheenvironment.