Specifications

61
Removalandinstallationoftheigniterandtheamesensor
CAUTION!
Whenreplacingtheigniterandtheamesensor,useonlythesetofspares“burnerspareparts
subject to wear” available from your Condair supplier, since otherwise the humidier could be
damaged.
1. Takethehumidieroutofoperation,asdescribedinchapter7.5.
2. Undothescrew(s)(phillipsscrewdriver)andremovetherightsidepanel(s).
3. Disconnectthewiringconnectiontotheigniterandtotheamesensor.
4. Unscrewthexingnutsfortheigniterandtheamesensor.Nowcarefullyremovetheigniter
andamesensor.
CAUTION!
Thesiliconcarbideigniterisbreakable.Thereforehandleitwithgreatcaretoavoiddamage.
Reinstallationisachievedbyfollowingthereversesequence.Inspectgasketsandreplaceifdefective.
Makesurethatallgasketsareinsertedcorrectlyandallcablesareconnectedcorrectly.