Specifications

23
TheCondairGShumidiersmustbemountedontheunitstand supplied with the unit. If mounting
on the unit stand supplied is not possible in your particular case, select a method of mounting that
is of similar stability. In case of doubt, please contact your Condair supplier.
5.2.2 Mountingthehumidier
Mounting instructions
1. Assembletheunitstandasshownintheseparateinstallationinstructions.Handtightenallbolts
only.
2. Liftuphumidierwithaliftingdeviceapprox.900mmabovetheoor.
3. Positionunitstandbelowthehumidier.
4. Lowerthehumidierandalignwiththeholesoftheunitstand.
5. Fastenthehumidiertotheunitstandusingthebolts,cupwashersandnutsprovided.
6. Tighten all nut and bolt pairs to 22.6 Nm (200 lb-in) or until secure.
7. Positiontheentireassemblytothedesiredlocation.Makesurethehumidierisstable,shimming
oftheoorbelowthesupportlegsoftheunitstandmaybenecessary.
8. Fixtheunitstandtotheoor(mandatory)viathefourholesinthesupportplatesoftheunitstand.