User guide

TrueFeed manual

All Conair TrueFeed feeders are equipped with the 2A (LT) stepper motor as standard. In case you are using

an A30 feed auger, the 4.5A (HT) stepper motor will be supplied. The A20 auger can also be connected to the

HT motor.

 Do not select the HT setting in the control if a LT motor is connected. This will damage the motor.

If a LT motor is selected and a HT motor is connected, there will be less motor torque which can influence

the feeding of additive.

The control of the TrueFeed makes a distinction between two groups of materials, normal granules and micro-

granules. To determine the type of material in your application use the description below.

* For other sizes contact a Conair representative.

The actual capacity of the feeding system depends on:

• The volume weight of the material (bulk density)

• The specific weight of the material (specific density)

• The granular shape of the material

• The granule size

• The surface structure of the material

 Granular material can be normal or micro. The granular material or powder material must be free flowing,

non-static and not sticky.

2A (LT) Stepper motor

4.5A (HT) Stepper motor

Normal Granules:

(NG) 3

Micro / Mini Granules:

(MG)

The term Micro/Mini Granules also

includes free flowing powder.

Ø < 0.2 in. {4 mm} L < 0.2 in. {4 mm} *

Ø < 0.1 in. {2.5 mm} L < 0.1 in. {3 mm} *

Material types