User guide

TrueFeed manual
58
5.2 Cleaning/Disassembling the loader
The MV-loader assembly can easily be disassembled for cleaning without tools.
To clean the MV-Loader:
1. Disconnect the main power and compressed air sources.
2. Remove the material transfer hose from the inlet pipe of the loader.
3. Disconnect the three (3) quick release clamps on the inlet flange
4. Disconnect the ø0.23x0.16 in. {ø6x4 mm} compressed air hose from the push in fitting in the lid
(Pictured below).
5. Remove the stainless steel filter screen.
6. Remove the inlet flange.
7. Remove the sight glass.
8. If previous material is a “dirty” material, store the filter until the next run of that color and use extra
filters. Otherwise use clean shop air to blow out the entrapped dust remaining in the filter.
9. Clean the hopper assembly by wiping it clean with a clean dry cloth.
10. Clean the material transfer hose(s) and air wand. If previous material is a “dirty” material store the
soiled parts until the next run of that color and use extra parts for material transfer.
11. Re-assemble the loader parts in the reverse order.
• Ensure that before replacing the sight glass, no material is on the rubber o-rings at the bottom
and upper side of the sight glass.
• Reconnect the compressed air tube (picture below)
• Replace the filter in the correct direction, fine side down, rough side up.