User guide

TrueFeed manual
53
2.1 Tube support
When the MV-Hopper loader is supplied together with the TrueFeed, a tube support is installed on the
load frame (see picture below). If the MV-hopper loader is delivered subsequently to a TrueFeed, the
user needs to install the tube support. The tube support needs to be installed with two bolts on the
frame of the TrueFeed.
Function of the tube support
The tube support is needed to create a loop in the flexible hoses shown in the picture below. The loop
is necessary for a proper weigh function of the TrueFeed. The length of the loop should not be
changed. The 118 in. {300 cm} hose length must have a 34.7 in. {95 cm} loop. (for 6 L and 12 L
hoppers)