User guide

TrueFeed manual
2
2. General information
2.1 Safety
This equipment is only designed and may only be used for the feeding of dry additives.
Any use that is not in conformity with the instructions is considered improper and as such frees the
manufacturer from any liability regarding damage to equipment and/or persons.
Before turning on the unit for the first time, ensure that the main power voltage
applied is between 80 and 260 VAC.
Always turn off the TrueFeed and disconnect the main power plug from electrical power before
performing maintenance.
Ensure that all parts are securely fixed to the extruder or injection molding machine.
Dangerous voltages are present inside the TrueFeed control for up to two (2) minutes after the
TrueFeed has been turned off.
2.2 Certification
The Conair TrueFeed is designed and produced in conformity with the following European regulations:
•
Standards for machinery (health, safety and environment)
• EMC (electromagnetic compatibility)
• VEM (safety electric material)
• 98/37/EC, Annex 1
2.3 Operating environmental conditions
• The unit must be protected against weather conditions
• Operating temperature -4° to 158° F {-20° to 70° C}.
• Protection class: IP-50